Home | Brokerage | Services | News | About | Contact
JBoats Southwest 2014

Home | Brokerage | Services | News | About | Contact
JBoats Southwest 2014














Standard Draft



Standard Ballast







21 hp

21 hp

100% SA
























Hull & Construction

• Balsa core/biaxial E-glass vacuum infused hull laminate. Corecell/biaxial E-glass deck laminate. Engineered and built to current ISO and ABS structural standards.

• White gel coat hull with single bootstripe.

• Molded companionway slide-in seahood.

• ORC size molded foredeck toe-rails.

• GRP molded main structural bulkhead, bonded fore & aft on hull and deck with single opening to forepeak.

• Fore/aft and transverse keel support beams.

• Composite mast bearing beam with integral plate to secure mast step.

Keel & Rudder

• High aspect two-metal racing keel with lead bulb and stainless fin, flange mounted to a covered hull recess.

• Balanced high aspect rudder constructed using “E-glass” with custom carbon rudder shaft mounted in self aligning rudder bearing system.

• 60” wheel with grey leather cover recessed in molded cockpit wheel well.

• Steering system including idler sheaves, 6.5” radial drive, needle bearing with integral wheel brake, and chain/wire cables.

• Emergency tiller.

Spars & Rigging

• Autoclaved carbon fiber mast with double set of tapered aluminum spreaders, backstay crane, flush shroud terminations, sheaves for main, 2 jib & 2 spinnaker halyards, vang and boom gooseneck fittings, steaming light, internal wiring conduit, pre-formed mast wedge kit. Mast/boom finished in black with contrasting white measurement bands. White finish optional.

• Alloy 6061-T6 Boom with 12:1 internal outhaul, two mainsheet block bales, vang lug, three sheaves for reef lines and outhaul.

• Nitronic 50 discontinuous rod standing rigging package including shrouds and forestay.

• Calibrated shroud turnbuckles.

• Dyneema DSK-78 Backstay.

• Remote hydraulic backstay system mounted within reach of helmsman on front face of wheel pedestal.

• Low-profile headsail furling system with control line aft to port side of cabin trunk.

• Carbon fiber, retractable bow sprit with internal bearing system painted black.

• Complete running rigging package

Deck Hardware

• 46:1 self-tailing primary winches.

• 40:1 self-tailing cabin top winches.

• (2) 10” winch handles.

• Two winch handle holders.

• Two-speed Mainsheet System with 6:1 rough tune purchase to swivel cam base & 24:1 fine tune purchase led to centerline ratchet cam.

• 4:1 Traveler System – led P&S.

• 6:1 Adjustable Jib Lead System.

• Jib in-hauler hardware & 4:1 tackle P&S.

• 6:1 Cunningham system.

• Blocks for spinnaker sheet and tack line.

• Bow-sprit control system led internally to cockpit mounted cam cleat.

• Mast base halyard blocks and Spinlock 4-sheave organizers P&S.

• Halyard & tack line rope clutches.

• Custom SS mast collar with pins for halyard blocks and halyard bale.

• Stainless cabin top handrails P&S.

• Tapered lifeline stanchions.

• Double lifelines to meet ORC offshore regulations with 9” lower lifeline height.

• Custom bow pulpit and dual corner stern rails with LED navigation lights.

• Four 8” 4-bolt SS mooring cleats.

• Four SS padeyes for cockpit spinnaker blocks.

• Interior ventilation from two framed opening ports in sides of cabin trunk and offshore style forward skylight deck hatch above V-berth (option for two opening ports on aft cabin face).

• Acrylic offshore drop-board with key lock and inside operable latch/unlatch.

• Cockpit operated manual bilge pump.

• Two 12"x 20" polypropylene mesh line bags.

• Custom SS stemhead, shroud and backstay chainplates.

Auxiliary Power

• Yanmar 3YM20 3 cylinder 4-stroke 21hp diesel engine with 60 amp alternator and SD 20 saildrive with 2-piece split zinc.

• Yanmar engine instrument panel mounted in recess on cockpit wall near wheel

• 16 x 11 diameter geared folding prop.

• Engine throttle control with neutral safety switch.


• 18-gallon fuel tank with baffles and inspection/clean out port.

• 12-gallon head holding tank.

• Marine head with Y valve and deck pump-out access.

• 26-gallon water tank.

• Manual fresh water foot pumps in head and galley.

• 90 amp deep-cycle, sealed AGM battery.

• Three position battery switch.

• Electrical panel w/circuit breakers.

• LED Navigation lights to meet COLREGS.

• Bonding system.

• Six reading lights.

• One adjustable nav light.

• Two red/white LED dome lights

• One fluorescent light in head.

• Automatic bilge pump & panel switch for manual/auto operation.


• Off-white low-maintenance bulkheads.

• Molded engine box cover with 1” sound insulation.

• Powder-coated aluminum companionway ladder w/teak treads.

• Twin 6’9” quarter berths aft of the galley/nav area with storage below.

• Main bulkhead privacy door.

• Teak and holly style synthetic high-wear cabin flooring.

• SS overhead handrails in main salon P&S.

• Two Large acrylic fixed portlights.

• 6’4” settee berths with backrests (fold-up pilots optional).

• Shelf outboard of settee berths with storage behind backrest cushions.

• Nav Station/Office with full leg room, hinged-lid access to chart storage, outboard instrument panel and storage bin.

• L-Galley with sink, faucet, fresh water foot pump, sink drain seacock, ice box with top opening, two-burner alcohol stove and storage cabinet outboard.

• Head compartment with sink and outboard storage to port and large sail/tool storage bin to starboard.

• Choice of nylon fabrics for interior cushions.


• Two tone deck.

• 1/2" Cove stripe to match boot stripe.

• Additional 90 amp battery.

• Opening ports on aft face of cabin house (2).

• Cockpit dodger with side curtains.

• Main cabin fold-up pilot berths.

• Wide-opening lifeline gates (P and/or S).

• Spar Package finished in white.

• 110 VAC Shore Power system with 30’ cord, 2 outlets, 20 amp battery charger, equipment leakage circuit interrupter (ELCI), and galvanic isolator.

• DC Refrigeration (requires 2nd battery option).

• Black Powder Coated Wheel, Stanchions and bow/stern rails.

• Quattro Secondary Winches in lieu of standard.

• LPG 2 burner cook top stove and cockpit LPG locker with 6lb tank, in lieu of standard.

• Removable V-Berth with platform, cushions and two reading lights.

• Varnished main cabin table with stainless base.

• Fiberglass molded cockpit locker storage liners (2) installed in locker openings.

Comfort Group Package:

• Cockpit seat and helmsman cushions (4 piece set); Sunbrella covered lifeline covers (4 piece set); mainsail cover
in Sunbrella with J/111 Logo.

• Interior Trim Package:

• Varnished wood trim along top and bottom of main bulkhead (in salon area) and varnished wood main bulkhead door.

Systems Group Package:

• Hot & Cold Pressure Water system; Cockpit Shower.


Specifications are subject to change prior to delivery due to deletions, additions or revisions in quantity, brand or design at the sole discretion of J Boats, Inc.

item4 item3